- Reset hp jetdirect 170x to factory default how to#
- Reset hp jetdirect 170x to factory default manual#
- Reset hp jetdirect 170x to factory default plus#
Type in ? and press Enter again to check your settings. Use the telnet toggle to turn DHCP off (otherwise the JetDirect will default to its factory setting if it loses power). In my case, my Mac's IP address was 192.168.1.2, so I used 192.168.1.200 for the JetDirect. Repeat the reset procedure, and make sure you do it right.)Ĭhange the JetDirect settings to the same range as the original Mac settings you took a note of earlier above (except for the specific IP address), including the Subnet Mask and Network Server. (If you cannot connect to the JetDirect or printer, the problem is almost certainly with the Cold Reset.
Reset hp jetdirect 170x to factory default how to#
If not, type ? and press Enter now you will see both the settings and how to change them. When you do, the JetDirect's settings should display.
Reset hp jetdirect 170x to factory default manual#
Change the IP address to 192.0.0.10 Use Manual settings, not DHCP (dynamic host configuration protocol).Ĭonnect your Mac directly to the JetDirect with an Ethernet cross-over cable, then open Terminal (in Applications » Utilities) and enter this command, then press Return twice: telnet 192.0.0.192. This is just temporary, so take a note of the settings before you do this, including the Subnet Mask and Network Server. Now change your Mac's IP address to the same range as the JetDirect, so that your Mac can connect (System Preferences » Network » Ethernet). The IP address will usually be 192.0.0.192, with no subnet mask or network server specified. After the JetDirect has been going for at least two minutes, just press the Test button once and it will print out its configuration pages. Next, find the IP address of the print server. Sounds weird, but this is the only way it will work. Then reconnect all cables and power up again. Then plug power in while holding the Test button down for 10 seconds, then unplug power holding the Test button down for another 10 seconds. For the JetDirect, remove all cables (including power). This step should never be omitted, as it resets to factory defaults and makes the server reachable on a network to change its details (more on that later).ĭoing a Cold Reset on most HP products is not as simple as turning the power off then on again. First, do a Cold Reset of the print server.
Reset hp jetdirect 170x to factory default plus#
The following relates to an HP JetDirect EX Plus print server (J2591A), but can be adapted for most hardware. So an HP print server (or a networkable printer) should work, right? Tunrs out it's not as easy as it sounds - not because of Snow Leopard, but because of a few vital details which HP's help desk and tech forums don't mention. Snow Leopard doesn't support AppleTalk, but has IP print protocols built-in.
0 kommentar(er)
